Select a tool. And change its container.
-
THE POST BELOW IS MORE THAN 5 YEARS OLD. RELATED SUPPORT INFORMATION MIGHT BE OUTDATED OR DEPRECATED
On 26/12/2006 at 15:20, xxxxxxxx wrote:
User Information:
Cinema 4D Version: 9.6
Platform: Windows ;
Language(s) : C++ ;---------
How can I select some tool?
And how to get its container?
For example I want to make a command that select the Knife tool and set its Mode to "plane" and Plane to "X-Y". -
THE POST BELOW IS MORE THAN 5 YEARS OLD. RELATED SUPPORT INFORMATION MIGHT BE OUTDATED OR DEPRECATED
On 26/12/2006 at 15:59, xxxxxxxx wrote:
Sounds like you'll need to use FindPlugin(ID, C4DPL_TOOL) and then get the BaseContainer using GetDataInstance(), for instance.
The hard part is knowing the ID and getting the specific Attribute Manager/Active Tool settings. These should be stored somewhere in the Resource folder (_api or res or modules possibly).
-
THE POST BELOW IS MORE THAN 5 YEARS OLD. RELATED SUPPORT INFORMATION MIGHT BE OUTDATED OR DEPRECATED
On 27/12/2006 at 01:40, xxxxxxxx wrote:
Thanks a lot !!!!
-
THE POST BELOW IS MORE THAN 5 YEARS OLD. RELATED SUPPORT INFORMATION MIGHT BE OUTDATED OR DEPRECATED
On 27/12/2006 at 01:51, xxxxxxxx wrote:
hmmm ...
And another question...
How can I make some tool active ( display its parameters in AM ) ? -
THE POST BELOW IS MORE THAN 5 YEARS OLD. RELATED SUPPORT INFORMATION MIGHT BE OUTDATED OR DEPRECATED
On 27/12/2006 at 06:20, xxxxxxxx wrote:
When the tool is selected, it´s descriptions get display in the AM automatically! Reshowing it, is simply reactivating the tool.
Working on a tool for your edge slide pluggy?
Keep it up.
-
THE POST BELOW IS MORE THAN 5 YEARS OLD. RELATED SUPPORT INFORMATION MIGHT BE OUTDATED OR DEPRECATED
On 27/12/2006 at 07:54, xxxxxxxx wrote:
"When the tool is selected, it´s descriptions get display in the AM automatically"
But how to select it? By C++.
...
Actually I put aside MultiSlide, and make another plug. -
THE POST BELOW IS MORE THAN 5 YEARS OLD. RELATED SUPPORT INFORMATION MIGHT BE OUTDATED OR DEPRECATED
On 27/12/2006 at 08:00, xxxxxxxx wrote:
The user selects it.
Or do you need this for something different? Maybe it would be better to explain why you want to select a tool yourself?Anyway, select a tool by this: doc->SetAction(PLUGINID_OF_TOOLPLUGIN);
If this doesn´t work, try a GeSyncMessage(EVMSG_TOOLCHANGED); //or another message type
So, what plug are you workin on?
Hope that helps
Samir -
THE POST BELOW IS MORE THAN 5 YEARS OLD. RELATED SUPPORT INFORMATION MIGHT BE OUTDATED OR DEPRECATED
On 27/12/2006 at 08:19, xxxxxxxx wrote:
It is for some commands I need to have, and I want to write it on c++ not on COFFEE
And for one tool ... it is long to explain, you will see it
Thank you very much ! It is just I looked for ! -
THE POST BELOW IS MORE THAN 5 YEARS OLD. RELATED SUPPORT INFORMATION MIGHT BE OUTDATED OR DEPRECATED
On 27/12/2006 at 08:34, xxxxxxxx wrote:
xarashoa